24
Operation
6004067_a – 01.08.2018
To achieve an optimal efficiency in removing cooking fumes:
☞
Turn the device on 1-2 minutes before you start cooking.
This allows the flow of air to build up, and the fumes are
removed at an early stage.
☞
In order to collect the cooking fumes effectively, use the
rear hob plates for intensive cooking.
☞
Avoid cross-currents (e.g. draughts) across the hob.
☞
During the cooking process, switch to a power level that
is appropriate for the intensity of the cooking vapours:
y
Power level 1 - lowest fan power
y
Power level 2 - medium fan power
y
Power level 3 - high fan power
☞
If the intensity of the cooking vapours does not subside,
switch to a higher power level.
☞
Switch to the POWER setting if frying.
☞
Turn on the run-on function when you have finished
cooking.
D
“4.3.1 Run-on function” (page 24).
☞
Check the fresh air supply at regular intervals.
☞
Use the device also to reduce other unpleasant smells.
Such as from:
y
Onions and garlic
y
Oven, microwave and steamer
y
Fondue and raclette
D
WARNING
Fire hazard due to grease residue!
In operation grease residue, which is highly inflammable,
collects in and on the device.
☞
Clean the device properly.
D
If you switch the machine on and hear an unusually loud fan
noise:
☞
Clean the device.
☞
Observe the stipulations for cleaning.
D
If you switch the machine on and notice a smell:
☞
Change the filter filling.
☞
Observe the stipulations for changing the filter filling.
D
“6.2.2 Replacing filter filing (with recirculating and
hybrid mode)” (page 28).
After 6 hours without operation, the device (including
lighting) automatically switches off.
4.3.1
Run-on function
The device comes with a run-on function. If this function is
used, the device will work for a further ten minutes at the last
chosen power level.
In recirculated air mode, it is necessary to use the run-on
function so that the device can remove the remaining
odours. Using the run-on function increases the life of the
filter filling. The filter filling must be replaced at regular
intervals.
The run-on function can be switched on manually or
automatically. The automatic run-on function is activated in
configuration mode.
D
“4.4 Configuration” (page 25).
Touch
field
Function
The device is switched on.
If the automatic run-on function is activated:
☞
Touch the touch field 1x.
The device switches off.
The run-on time starts automatically in the last
selected power level.
If the automatic run-on function is not
activated:
☞
Touch the touch field 2x - within
2 seconds.
The device switches off.
The run-on time is started manually in the last
selected power level.
During the run-on time (10 minutes), the
operating symbol for the selected power level
will flash.
4.3.2
Extraction mode / recirculated air mode
changeover
If the device is configured for hybrid mode, it is possible to
switch between extraction mode and recirculated air mode
at any time after activating the changeover function.
The changeover function is activated in configuration mode.
D
Summary of Contents for Moveline BTH 100 ML
Page 35: ...35 6004067_a 01 08 2018 EN ...
Page 36: ...6004067_a 01 08 2018 ...
