48
Installation
6003594_0 – 29.06.2017
D
ATTENTION!
Danger of damage to the front panels!
The front panels can detach from the assembly profile and
fall, if the glue is not used correctly.
☞
Make sure the glue is processed correctly (e.g. cured),
before performing the next assembly steps.
☞
Carefully break off the pre-punched brackets.
☞
Fit the front panels to the long sides top and bottom.
To do so, position the cut-out of the assembly profile on
the screws of the ceiling lift hood.
☞
Align the front panels with the long sides as follows:
y
Tighten the screws on both short sides until hand-
tight (turn to the left).
y
Align centrally by evenly adjusting the screws on both
short sides.
☞
Make sure that the front panels on the long sides are
secure by tightening the screws on both short sides until
hand-tight (turn to the left).
☞
Fit the front panels to the short sides top and bottom.
To do so, insert the screws of the assembly profile in the
cut-outs on the ceiling lift hood.
Summary of Contents for Skyline Edge BDL 115 SKE-I
Page 52: ...6003594_0 29 06 2017 ...
