Berbel Smartline BIH 100 ST, Operating And Installation Instructions

10

Installation

6005736_0 – 25.03.2021

3.5 

Installation procedure

Short overview:
1.  Preparation for installation
2.  Unpacking the device
3.  Determining the hanging position
4.  Hanging the chimney stack
5.  Hanging the hood body
6.  Connecting accessories
7.  Connecting the power supply
8.  Fitting the BackFlow port
9.  Installing filter (with recirculating and hybrid operation)
10. Connecting exhaust air ducting (with extracted air and 

hybrid mode)

11. Fitting chimney cover
12. Inserting lower section and separating unit
13. Check and carry out commissioning

3.5.1 

Preparation for installation

☞

Familiarise yourself with the installation situation and the 
associated documents.

y

Device and instructions.

y

Accessories.

y

Installation location.

y

Intended operating mode.

☞

Assemble the tools and materials required:

y

Stable stepladder

y

Folding rule or measuring tape

y

Pencil

y

Spirit level

y

Plumb line

y

Phillips screwdriver PH2

y

2.5 mm Allen key

y

Slotted screwdriver SL 2.5 x 0.4

y

7 mm spanner

y

13 mm spanner

y

Ø 8 mm masonry bit

y

Hammer drill

y

Rivet tool

y

Cutter blade

y

Protective material (e.g. thick cardboard) for the hob 
and the worktops

☞

Keep the installation area free of objects that could be in 
the way or that could be damaged.

☞

Make sure that the hob and other parts that could be 
touched have cooled down.

☞

Protect the hob and other surfaces in the installation area 
(e.g. with thick cardboard).

☞

Ensure that the power supply is switched off and remains 
so. Connect the power supply only when instructed to do 
so in the installation instructions.

If accessories (e.g. wall box, window contact switch) are 
required for the installation:

Observe the instructions for the accessories.

☞

Ensure that the accessories are correctly installed and 
ready for connection.

☞

Ensure that the connection cables from accessories are 
correctly routed and accessible.

3.5.2 

Unpacking the device

D

ATTENTION!

Hazard of glass breaking or other damage due to 

incorrect handling!

The device and its surfaces can be damaged when being 
unpacked or transported.

☞

Do not cut into the protective cardboard packaging.

☞

Keep objects that could scratch the device far away from 
it (e.g. tools, belt buckles).

☞

Unpack the device and all accompanying parts carefully.

☞

Set the device down on a firm, clean and protective 
surface (e.g. thick cardboard).

☞

Check the device and its constituent parts for damage. 

☞

Check the delivery is complete. 

D

“2.4 Scope of delivery” (page 6).

If parts are missing or damaged:

☞

Please consult your dealer or customer services.

☞

Remove the packaging material and the protective film.

D

“8.1 Disposing of packaging” (page 31).