105
Operation
6003417_a – 26.09.2017
EN
The active power setting is displayed by the LEDs illuminated
beneath the buttons:
y
1 LED lights up = Power setting 1
y
2 LEDs light up = Power setting 2
y
3 LEDs light up = Power setting 3
To achieve an optimal efficiency in removing cooking fumes:
☞
Turn the device on 1-2 minutes before you start cooking.
This allows the flow of air to build up, and the fumes are
removed at an early stage.
☞
In order to collect the cooking fumes effectively, use the
rear hob plates for intensive cooking.
☞
During the cooking process, switch to a power level that
is appropriate for the intensity of the cooking vapours:
y
Power level 1 - lowest fan power
y
Power level 2 - medium fan power
y
Power level 3 - high fan power
☞
If the intensity of the cooking vapours does not subside,
switch to a higher power level.
☞
Switch to power setting 3 if frying.
☞
Turn on the run-on function when you have finished
cooking.
D
“4.3.1 Run-on function” (page 105).
☞
Check the fresh air supply at regular intervals.
☞
Use the device also to reduce other unpleasant smells.
Such as from:
y
Onions and garlic
y
Oven, microwave and steamer
y
Fondue and raclette
D
WARNING
Fire hazard due to grease residue!
In operation grease residue, which is highly inflammable,
collects in and on the device.
☞
Clean the device properly.
D
If you switch the machine on and hear an unusually loud fan
noise:
☞
Clean the device.
☞
Observe the stipulations for cleaning.
D
If you switch the machine on and notice a smell:
☞
Change the filter filling.
☞
Observe the stipulations for changing the filter filling.
D
“6.2.1 Replacing filter filling” (page 108).
After 6 hours without operation, the device (including
lighting) automatically switches off.
4.3.1
Run-on function
The device comes with a run-on function. If this function is
used, the device will work for a further 10 minutes at power
setting 2.
In recirculated air mode, it is necessary to use the run-on
function so that the device can remove the remaining
odours. Using the run-on function increases the life of the
filter filling. The filter filling must be replaced at regular
intervals.
Button
Function
The device is turned off.
☞
Press button 1x.
The device switches on the run-on function
with power setting 2.
The run-on function is switched on.
☞
Press button 1x.
The run-on time starts again (10 minutes).
When the power stage changes, the run-on
function is ended.
During the run-on time (10 minutes), the LEDs
for power settings 1 and 2 will flash.
4.3.2
Hob lighting
The hob lighting is fitted with energy-saving LED lighting.
The lighting can be used at any time and independently of
the fan.
Button
Function
☞
Press button 1x, in order to switch the hob
lighting on or off.
Summary of Contents for Smartline BKH 80 ST
Page 112: ...6003417_a 26 09 2017 ...
