7
INSTALLATION
7 UNPACKING THE PRODUCT
Solar collectors are supplied in packages containing 1, 2
or 5 panels
Pallet contents:
- collector
- document envelopes containing instruction manual,
bar code labels and data label.
2
2
1
b
Be careful not to lose the two flat gaskets (1) in the
corner (2) of each collector.
b
The instruction manual is an integral part of the so-
lar connector. Once located, read it thoroughly and
keep it safe.
b
STORE IN A DRY PLACE AND DO NOT EXPOSE TO DI-
RECT SUNLIGHT UNTIL THE TIME OF INSTALLATION!
The packaging is not designed to protect the product
against rain or humidity. It can also degrade if ex-
posed to direct sunlight. Failure to comply with these
precautions could lead to irreparable damage to the
product.
b
A protective film is applied on the collector glass, gen-
eral and handling information is written on it. It must be
removed after the installation of the solar collector, only
when the operation of the system is required.
Installation
8 HANDLING
- Separate the solar collector from the wooden pallet
by removing the film wrapping
- Apply the data label (provided in the document enve-
lope) to the back of the solar collector
Once you have removed the outer packaging, proceed as
follows to unpack and handle the solar collector:
- Tilt the solar collector slightly and grip it at the four
points shown (A) to lift it.
- Use a hoist or other suitable lifting equipment to hoist
the solar collector on to the roof.
Data label
A
A
A
A
Codice . . . . . . . .
Modello . . . . . . .
Matricola . . . . . .
Codice . . . . . . . . . . . . . . . . . . . . .
Tipo . . . . . . . . . . . . . . . . . . . . . . .
Dimensioni. . . . . . . . . . . . . . . . . .
Superficie lorda . . . . . . . . . . . . . .
Superficie di apertura . . . . . . . . .
Superficie assorbitore . . . . . . . . .
Peso a vuoto . . . . . . . . . . . . . . . .
Massima pressione di esercizio .
Contenuto liquido . . . . . . . . . . . .
Massima concentrazione glicole .
Liquido termovettore . . . . . . . . . .
COLLETTORE SOLARE (neutro)
FABBRICATO IN ITALIA da Riello S.p.A.
Temperatura di stagnazione . . . .
°C
TCOLL_NEUTRO2
b
Wear suitable personal protective equipment and
use suitable safety devices.
a
Do not dispose of packaging material into the envi-
ronment, or leave it within the reach of children, since
it can become a potential hazard. Dispose of packag-
ing material in compliance with applicable legislation.
a
Do not lift the solar collector by its water fittings.
