Translated user manual (EN-V1)
BENOMIC S500
27 / 57
7.11
Pipe - concrete path transition
With the pipe-rail (harvesting path) to concrete path transition, the
BENOMIC S500
automatically stops running when the pipe-rail sensor (in the middle of the trolley) no
longer detects any pipe-rail. However, it is recommended that the user knows when the
concrete path is approached in order to reduce the speed and stop in time. See also
8.3.2.
7.12
Stabilizers & platform height protection
Stability must be ensured in order to work at height. Therefore, the BENOMIC S500 is
equipped with stabilizers at the front and rear of the trolley. Depending on the type of pipe
rail system, it is necessary to use these stabilizers in order to work at height. See chapter
10.1 'Explanation of technical specifications' for the list of restrictions that apply.
If the ground has insufficient bearing capacity, work at height may not be performed, see
recommendations in chapter 7.3.
For the operation of the stabilizers see 8.4!
If the stabilizers are used in the described manner the 3-scissors can be used up to 5
meters working height.
7.13
Speed limitation when driving at height
In order to ensure the safety of the user when driving at height, the BENOMIC S500 is
equipped with a speed limiter that comes into effect when the pipe rail trolley is driving at
a height of 4 meters.
Maximum travel speed at working height < 4 m: 60 m/min
Maximum travel speed at working height > 4 m: 30 m/min
