Translated user manual (EN-V1)
BENOMIC S500
31 / 57
6. DIRECTION OF TRAVEL REVERSE SWITCH
The direction of travel selected is determined by setting the selector to the desired
direction.
7. SPEED CONTROL KNOB
0 = idle 10 = maximum speed
8. EMERGENCY STOP
Only use in case of emergency! The main switch (1) must be used for switching off.
- Press = stop
- Turn-pull out = release
When an emergency stop is activated, you will hear an acoustic signal (1 bleep every 3
seconds) for 1 minute, and the Red indicator will blink slowly. After the minute of sound,
only the red signal lamp will continue flashing slowly.
After 2 minutes, the
BENOMIC S500
goes into a “sleep mode", the signal lamp (11) and
the battery condition meter (13) are no longer illuminated.
This sleep mode is only activated if the work platform is lower than 80 cm.
If the emergency stop is released within two minutes, the signal lamp will flash blue, then
press HORN/RESET button (10) briefly to re-activate the
BENOMIC S500
for operation.
Starting up after engaging the emergency stop or “sleep mode” active
Never release an emergency stop (reset) if you do not know who engaged
the emergency stop and why.
Release the emergency stop only when the dangerous situation has been averted!
Then press the HORN/RESET button (10) to activate the
BENOMIC S500
for use. (also
see 1. MAIN SWITCH/EMERGENCY STOP)
9. WORK PLATFORM DOWN/UP, ROTARY SWITCH
The rotary switch can be used to lower or raise the work platform when the pipe-rail trolley
is completely installed on the rails. The platform will lower as long as the knob is turned
counter-clockwise.
Beware of people or objects in the vicinity of the scissors while lowering!
An acoustic signal will sound while the platform slowly lowers during the final
stage of lowering!
The scissors will rise to a maximum platform height as long as the button is turned up
clockwise. The maximum height is 5 metres, depending on maximum load, see 10.1
(Explanation of technical specifications). If necessary, stabilizers must be used.
Release the button as soon as the work platform has reached the maximum height!
10. HORN / RESET
Use the horn if you want to warn someone, an acoustic signal is audible as long as the
push-button is pressed.
Use the horn / reset button (10) to activate the
BENOMIC S500
, ‘reset’ after using the
main switch (1) or the emergency stop (8). After this operation, the indicator (11) will light
up Green continuously when the
BENOMIC S500
is in a safe status, it is then ready for
use.
