Translated user manual (EN-V11)
BENOMIC
27 / 43
8.8
Disposal
If your
BENOMIC
has to be disposed of, for whatever reason, this must be carried out by
your supplier or by another company that specialises in dismantling vehicles. On no account
should you take your
BENOMIC
to a scrap dealer or to the rubbish tip. The
BENOMIC
should be dismantled and the chemical parts including hydraulic fluids and battery acid
removed separately.
Return faulty batteries to your local authority cleansing department or your supplier.
Treat oil as a chemical waste.
9.
Repairs & maintenance
The
BENOMIC
is a very high quality product. In order to guarantee that the high level of quality
remains, it is vital that the maintenance scheme given below is strictly adhered to. Repairs and
maintenance activities should be recorded in the maintenance log book (see appendix 1). The
employer is also responsible for periodically checking tools and equipment according to the
current national regulations covering this subject.
Disconnect the
BENOMIC
by the main switch before starting maintenance:
Maintenance - Check
Tools
Day
Week
Month
Year
Battery sufficiently charged
Battery condition indicator
X
Damage to the control equipment
Visual
X
Damage to and visibility of the symbols and
stickers
Visual
X
Foot pedal + platform cleaning
Brush / Damp cloth
X
Clean control panel
Brush / Damp cloth
X
Clean chassis sliding blocks for scissor
Brush / Damp cloth
X
Check for leaks and damage to cables and
hoses
Visual
X
Check for waste material or string etc twisted
around wheels and chains
Visual
X
General mechanical damage
Visual
X
Check raising and lowering movements for
jamming (low hydraulic fluid levels)
Hydraulic fluid
ISO Viscosity Grade 46
X
Check for height safety without stabilizers
Visual - only the 3-4 scissor model
X
Charge batteries when needed or at least once
a month
Battery charger
X
Check battery electrolyte levels (plates covered
1cm depth electrolyte - see Appendix 3)
Distilled water, protective gloves
and safety goggles
X
Check the operation of the alignment warning
Test > 2 degrees
X
Check hydraulic components under the cover
plate for leakage (pump and valves)
Tools for removing cover plate bolt
X
Grease lift wheels, drive chain and ball
bearings
Grease for ball bearings and
chains or a universal lubricating
grease
X
Check chain tension (see 9.5)
Open-ended spanner
X
Fixing caps on the scissor shafts
Visual
X
Have the motor's carbon brushes cleaned
and those smaller than 1 cm replaced (see
9.4)
Compressed air / Visually
X
Grease all hinged parts of the scissor assembly
(see 9.2)
Grease gun and grease
X
Grease all hinged parts in the lift system
Grease gun / WD40 / lubricating
grease
X
Check the welds on the scissor construction for
cracks (hair cracks) and rust.
Visual
X
If it appears from the above checks that there is a fault with the
BENOMIC
, please contact your
BENOMIC
dealer immediately. Continuing to use the trolley with the identified defects can be
very dangerous and is therefore forbidden!
