Translated user manual (EN-V11)
BENOMIC
29 / 43
Fig. 7.3 - Inspection motor carbon brushes
9.4
Inspection carbon brushes
1. Raise the
BENOMIC STAR
thereby making the motor accessible. 2. Blow the carbon brushes
clean with compressed air 3. Unscrew the grill, 4. Pull up the carbon brush, 5. Carbon brushes
less than 1 cm long should be replaced - consult your dealer.
9.5
Tensioning the chain
The chain tension should be approximately 1cm - if not, carry out the following:
1. Switch off the
BENOMIC
at the main switch and remove the key from the slot to avoid the
BENOMIC
being switched on again.
2. Lift up the trolley using a forklift truck, for example (see 6.2 Internal transport)
3. Unscrew the blocking nut (picture A)
4. Tighten the chain by rotating the adjusting bolt (picture B)
5. Fix the adjusting bolt in place by fully tightening the blocking nut again (picture A)
* ensure that the chain play is approximately 1cm (picture C)
C
Fig. 7.3 A-B-C - Tensioning the chain
