Berg Hortimotive
2-2016
Translated user manual
BRW185 V3_2016
19/27
Before charging turn off the Trolley with the main switch, second connect the
charger to the batteries before turning the charger on. When recharged, turn the
charger off bef
ore disconnecting. Recharging “too far” can damage the batteries as
the battery fluid boils for longer than necessary. It is advisable to use a modern
battery charger with automatic cut-out.
Only use a charger suitable for a 24V-110Ah
Wet
battery (see instructions on
charger).
- Never interrupt the recharging process until fully finished
- During battery recharge do not repair, clean or carry out any other activities to the
pipe rail trolley
- When dismantling the batteries, disconnect all power consumers in order to avoid
spark formation.
- At dismantling, the negative cable (-) needs to be disconnected first. Conversely,
when installing, connect the negative cable last.
CAUTION!
Always connect the positive (+ = red) to the positive pole and negative (- =
blue) to the negative pole.
Battery fluid is a corrosive acid
– prevent contact with clothes, skin and eyes. In the
case of splashes on skin or clothes, immediately wash with water and soap. Then
rinse with plenty of water. Acid splashes in the eyes should be rinsed with clean
water for at least 5 minutes. Medical advice should then be sought immediately.
Note
Check the permitted number of battery chargers on one group. You can check this by
multiplying amps of the fuse with the voltage. For example: 16A*230V = 3620W
Check the power consumption of the battery charger. Share the this capacity by the power
consumption of the battery charger. For example: 3620/700=5,17. 5 battery chargers can be
connected.
Check also if the tension on the charge location corresponds to the required tension which on
the battery charger indicate is. It can
Occur that tension loss appears in long cables.
When replacing batteries, hand your old ones in to your supplier or local authority.
