USER MANUAL 1.2 | B-FORTIS CC-PRIME SERIES
Berghof Automation GmbH | Arbachtalstrasse 26 | 72800 Eningen | www.berghof-automation.com
11
→
as intended
→
in a technically perfect condition
→
without any unauthorised modifications
→
by qualified users
Observe the rules of the employer’s liability insurance association, the technical
inspectorate, and the VDE (Association of German Electrical Engineers) or corresponding
country regulations.
The device is intended for installation into a suitable cut-out on industrial machines and systems
in indoor areas.
When installing the device, check that the seal profiles are undamaged.
For operation, refer to the applicable statement of ambient conditions (see "Chapter 10").
1.7. Transport and storage
The device is susceptible to impacts, heavy vibration, moisture and extreme temperatures.
Transport and storage
Protect the device against major mechanical stresses during transport.
Always pack the device in its original packaging for transport.
For storage, refer to the applicable statement of ambient conditions (see "Chapter 10
”).
Protect the device against condensation and damp.
Devices with batteries/rechargeable batteries
Lithium metal batteries are hazardous items. The manufacturer’s information specifies that they
are subject to UN 3091 (must be permanently installed within the device).
The ADR 188 special regulations can be applied for transport.
Operation
If the device has been stored or transported in cold weather or under conditions or large
fluctuations in temperature, do not start to operate it until it has acclimatised to room
temperature for the place it is used.
If condensation is present, wait at least 12 hours before starting to operate the device.
1.8. Unpacking
On receipt of the device, a check must be made that it is complete and undamaged.
Check the packaging for external damage.
