Connecting and installing the device
The RJ45 installing connector is mounted on the network cable.
Connect the jack to an RJ45 socket on the touch panel (7/8) using the
enclosed, pre-assembled RJ45 patch cable.
If required connect a 24 V DV auxiliary voltage (see Accessories) using the
enclosed terminal (9). Ensure correct polarity (fi gure 2/3).
Recommendations for connecting the supply voltage, see Prepare the
supply voltage.
Insert touch panel in the housing (21) in such a way that the mounting
plates (22) of the housing are pushed under the frame.
Tighten the four screws and the mounting plates through the frame from
above and below using the enclosed Allen key (Figure 12/13).
The screws must be countersunk in the frame.
(21)
(22)
(22)
Figure 12 a/b: Installation in the fl ush-mounted housing
(21) Flush-mounted housing (not included in scope of delivery)
(22) Mounting brackets
z
22
Summary of Contents for 7574 01 07
Page 27: ...z 27...
