5.1 Touch sensor with room thermostat
Mounting and connecting the Touch sensor
Figure 10
(5) Power supply connection
(6) Connection of wired floor temperature/remote sensors (accessories)
(7) KNX connection
(8) Programming LED
(9) Programming button
The device is installed by screwing the mounting frame to the appliance box or to the wall.
Increased dismantling protection is achieved by securing the device on the bottom of the
mounting frame using a retaining screw.
Use double flush-mounted box. Mounting on single flush-mounted boxes or surface-mounted
boxes is not possible.
Bus voltage and an additional power supply are available at the installation location.
i
The yellow and white wire pair of the KNX bus line can be used to provide an additional
power supply.
o
Align the mounting frame (10) and screw it to the appliance box or the wall (Figure 11).
Observe marking
TOP
= TOP. Use the enclosed set of screws.
o
Connect power supply to the terminal (5).
o
Connect the KNX bus voltage to the terminal (7).
o
Optional: Connect the external temperature sensor to the terminal (6).
i
Programming button and LED are accessible only from the back of the device. If possible,
load the physical address into the device before the final installation (see chapter 5.3.
Commissioning).
o
Attach the device onto the mounting frame until it locks in place.
o
Tighten the retaining screw (11) on the bottom of the mounting frame. Use a Pozi-Drive
screwdriver, size 0.
Seite 8/13
15.02.2013
32586901
97-09635-000
KNX
Touch/Glass sensor 2gang / 3gang with room thermostat
