Figure 11
(10) Mounting frame
(11) Retaining screw
5.2 Glass sensor with room thermostat
Preparing the Glass sensor for mounting on a smooth substrate
Figure 12
(12) Adhesion points for adhesive dots
(13) Retaining peg
The adhesive dots prevent the glass sensor from slipping when mounted on smooth surfaces.
o
Free the adhesion points for the adhesive dots on the rear side of the glass sensor (12)
from impurities.
o
Remove the adhesive dots from the carrier film and stick them to the four adhesion points.
o
Free the substrate of impurities.
o
Before mounting the glass sensor, remove the protective film from the adhesive dots.
i
Before completing mounting, align the glass sensor and press it in the area of the adhesive
dots, in order to fix it in place.
Seite 9/13
15.02.2013
32586901
97-09635-000
KNX
Touch/Glass sensor 2gang / 3gang with room thermostat
