Draft version 02 Operatots Manual / SmartMonitor SHIP L
page 19 of 26
•
Read-out via Bluetooth:
Read out via Bluetooth will be possible with a later version
13.5.2
Upload data manually of read out data to Berlinger SmartView
To upload the manually read out data to Berlinger SmartView software (version 6.0 and higher) you
have two possibilities:
•
Direct upload to Berlinger SmartView software (version 6.0 and higher):
Open Berlinger SmartView software (version 6.0 and higher), chose Device
→
Upload Data
File
→
Select the datafile to upload
→
confirm it by pressing Upload File(s)
•
Via e-mail:
Send the read out datafile via e-mail to qtag-upload@smartview.berlinger.com
13.5.3
Return device
If the transport is complete and the data are uploaded to Berlinger SmartView software (version 6.0
and higher), the device can be used for the next shipment.
Before the device will be used for the next shipment, follow the instruction at chapter Maintenance.
If the unit was rented from Berlinger, return it to Berlinger in accordance with the RMA process.
14
Where to place SmartMonitor SHIP L
Berlinger recommends to place SmartMonitor SHIP L as close as possible to the product to be
monitored so that the temperature can be recorded as accurately as possible.
If temperature monitoring is done with an external sensor, the external sensor should be as close as
possible to the product to be monitored and the SmartMonitor SHIP L can be mounted on the outer
cover.
Important:
If SmartMonitor SHIP L is mounted on the outer cover, Berlinger recommends securing the device so
that it cannot be damaged.
The cable of the external sensor should be mounted in such a way that it does not interfere with the
handling of the transport or can be pulled off.
