3
• Unpack all components carefully.
• Connect the ground stake to the rear side of frame of the solar panel.
• Connect two solar panels and then connect to the control housing.
• Place the pump underwater and make sure that it is
fully immersed
in water. Use the four flexible suction cups to stick the pump to the base
of the water feature / fountain. In case the pump tube is too far from the
surface of water, you can raise the pump off the bottom using stones.
• Assemble the fountain, fit the LED lights and fountain head as shown.
• Connect the pump power cable and lights power cable to the socket of
the control housing.
• The solar pump is now ready to use.
• Do not open control housing without permission.
• Always keep rubber plug in the "Charge" and "Light" socket.
Especially after using charger or light, remember to plug rubber back
into the socket, to avoid water leaking
Assembly
Warning
Solar Panel
Solar Panels
Control Housing
Ground
Stake
Fountain
Lights
Pump
