Bernal S 201-60, Instruction Manual

S 201                                                                                                                                                                                                          01-07

15

Error analysis 

Lighting:

• 

Light bulb defect: 

Replace by a 24V/15W (E14) light bulb 

• 

Opener does not have power supply:  

Check mains supply lines and fuses and replace if 
necessary 

Radio system:  

• 

Door does not react to transmitter signal:  

Check battery and replace it if necessary.  

Receiver did not learn / accept transmitter code; 
repeat programming. 

• 

Unsatisfactory transmission range:  

Check connection and placement of the antenna 
and correct if necessary.  

Check battery output and replace it if necessary.  

Use a rod antenna 

Logic board:

• 

Door does not move at all: 

Check if the inputs for safety device connection 
(NOT)are bridged, or if safety devices are con-
nected 

• 

Door only reacts on signal of a push button:  

Check placement of the radio receiver and correct 
if necessary 

• 

Door stops during the movement:  

Door is rough running, check door mechanic and 
correct it (only by a professional!!) 

• 

Door reverses during the movement: 

Check if there is a hindrance, remove it. 

Motor:  

• 

Motor is running but the door is not moving: 

Check connection of pushing rod and door and 
correct it if necessary. Is the connection piece of 
the chain or the belt engaged with the trolley? 

• 

Motor runs jerkily:   

Gear of the motor defect. Replace motor unit 

• 

Motor does not start running 

Check if the Hall sensor cable is connected in the 
correct way (at motor and at logic board) 

Radio system PICO, 868,5 MHz 

2 channel 

4 channel 

Application: remote control for garage door and 
gate openers

Technical data: 

- Frequency 868,5 MHz 
- Coding: KEELOQ®-Rolling Code System; pre-

programmed by the factory 

- Each receiver has a max. capacity of 28 transmitters, 

which can be programmed 

- Power supply: standard 3 V lithium coin cell CR2,032  
- Range approx. 50 m, depending on the surrounding field 

Battery replacement: 

Loosen the battery cap on the back side of the casing 
by turning it to the left side (see drawing) with your 

finger. Insert the new 
battery with its positive 
pole forward into the 
battery cap. Turn the 
battery cap together with 
the battery back into the 
casing. 

IMPORTANT: Do not throw used batteries into domestic 
waste; dispose them through battery recycling system! 

Transmitter types: 

2 and 4 channel 

Conformity: 

The radio system conforms to the standards of EN300,220-
3 V1.1.1; EN301,489-3 V1.4.1; EN60,335-1; EN50,371 and 
may be put in circulation without additional registration in 
the countries of the EU and in Switzerland. 

HomeLink®-compatible: 

The transmitter can also be programmed into HomeLink®-
systems of motor vehicles. Precondition is the relative 
actual software state of the system integrated (beginning 
with version 8). 
 

Transmitting 
direction 

T1

T2 

Transmitting 
direction 

T1

T2 

T3

T4