BERNINA
®
Embroidery
Module/Machine
M
ASTERING
Y
OUR
BERNINA
®
E
MBROIDERY
M
ODULE
/M
ACHINE
10
Mastering
Your
BERNINA
®
©2005 BERNINA® of America, Inc. Permission to copy granted only to Authorized BERNINA
®
Dealers
Hooping Fabric
• Find the center of the fabric
• Separate the embroidery hoop sections
- Loosen the screw. It should be loose enough that fabric
and stabilizer both will EASILY fit into the hoop
• Embroidery Templates
- Use to ensure that the motif is centered in the hoop
- Each hoop has a corresponding template
- When inserted correctly, “BERNINA” reads left to right,
right side up
- Template surface is marked in 1cm squares
- Each template has cut-outs to facilitate transfer of markings
to fabric
- There are finger holes to facilitate easy removal of the
small and medium hoop templates
- With the large oval and Mega hoop templates, special
attachment clips facilitate easy removal
• Secure fabric/stabilizer in the hoop
- Lay the outer hoop on a HARD, FLAT surface
- (
Deco
330 only: Place so the clamp lies off the edge
of the surface and the hoop lies flat.)
- Secure stabilizer to the back of the fabric by lightly coating
stabilizer with 505 temporary spray adhesive
- Place fabric and stabilizer on a firm surface
- Position template inside the inner hoop
- Position inner hoop on fabric, aligning any markings
- Grasping both inner hoop and fabric/stabilizer, insert them
into the outer hoop, making sure that the arrows align
at the edges of both the inner and outer hoops
- DO NOT DISTORT THE FABRIC when tightening the screw
on the hoop
- Hooped fabric should be taut, but not stretched or distorted
- Remove template before stitching
Attaching and Removing Hoop
• When attaching hoops, be sure to seat the frame securely.
• Release clamp completely before removing frame from machine
Notes
