Review and edit stored stitches
Press the memory button to enter the
memory mode, the screen shows the 1st
memory location.
(*Active memory location blinking)
2nd memory location
2nd memory location
3rd memory location
1st memory location
At the location to be modified press the enter
parameter button to change the setting of
stitch length, stitch width, mirror, elongation,
auto-stop and twin needle function.
Press the enter parameter button again to
store the changes (if any) and to go back
into memory scroll mode. Then move to the
next memory location to be edited.
Twin needle sewing in memory mode:
- Only regular sewing pattern can be sewn
with twin needle function. If any alphabet
letter was stored the twin needle function
will be disabled.
- With the twin needle function set no more
alphabet characters can be programmed
into the memory.
- If the twin needle function has been set for
any pattern in the memory the twin needle
function will automatically be applied for
the whole stitch pattern sequence and all
pattern will have the same stitch width
limitation.
Press the memory button to leave the
memory mode and return to the last selected
pattern group.
Use the stitch width adjustment buttons to
navigate to different memory locations and
to review the parameters set.
Special Functions
67
