DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS
200 Old Wilson Bridge Road
Columbus, OH USA 43085
(866) 928-2657
worthingtoncylinders.com | bernzomatic.com
06/24/15
•
Before heating a surface, check to make sure that heat will not be conducted to adjoining areas that may be combustible or
become pressurized when heated. During use, check adjoining areas frequently for unintended heating.
•
Work only in well-ventilated areas. Avoid the fumes from fluxes, lead-based paint, and all metal heating operations. Be careful to
avoid fumes from plated and galvanized metal
•
Ensure that torch is completely cool before storing. Always disconnect cylinder from torch for storage.
•
Brick and concrete can crack and explode when subjected to high temperatures.
•
Do not leave unattended.
•
Be careful on bright sunny days or under windy conditions. Bright sunshine can make it difficult to see the flame, and wind can
carry the flame or sparks to unintended areas.
•
Make sure grip does not cover air holes before using.
ASSEMBLY
1. Use only with propane or MAP-Pro™ gas cylinders.
2. Turn valve control knob fully clockwise to OFF position.
3. Hold cylinder upright, and screw it into the valve until it is fully seated and hand tight.
4. Leak test connection to cylinder before use. Do not check for gas leaks with a match or open flame. Apply soapy water at cylinder
connection. If bubbles appear disconnect cylinder.
5. Make sure the grip does not cover the air holes. If so, slide the grip away to expose the air holes prior to use.
Valve control
knob
Valve
Auto-start
button
Burner tip
Handle
LIGHTING AND OPERATION
1. Turn valve control knob ¼ to ½ turn counterclockwise to open the valve.
2. Depress the auto-start button to light. If the torch does not light right away, depress the auto-start button again.
TO USE
1. Inspect torch before each use. Do not use if torch malfunctions or is damaged.
2. Hold torch by the handle at the curved part of the tube.
3. Sweep burner tip back and forth over target area, keeping the flame about 2” above the ground.
4. SHUT OFF TORCH BEFORE SETTING DOWN.
TO SHUT OFF
1. Turn the valve control knob fully clockwise to OFF position.
2. Wait for flame to extinguish.
3. Set torch down on non-combustible surface and let cool, tip will remain hot for several minutes after torch is shut off.
STORAGE
1. Turn valve control knob clockwise to the OFF position. Do not force.
2. When torch is cool, disconnect cylinder and store torch and cylinder separately. Keep out of reach of children.
Observe warnings on cylinder label.
3. Do not expose cylinders to temperatures in excess of 120°F/49°C.
4. Store cylinders in well ventilated areas.
