Bertazzoni K31AMLF1XE.UA, User Manual

- 9 -

   INSTALLATION INSTRUCTIONS.

   OPERATING INSTRUCTION.

   READ AND SAVE THESE INSTRUCTIONS.

   GENERAL

Carefully read the following important information regarding installation safety and 

maintenance. Keep this information booklet accessible for further consultations. The 

appliance has been designed for use in the ducting version (air exhaust to the outside 

- Fig.1B).

   INSTALLATION INSTRUCTIONS

•  Power Supply Connection:

For connection to the power supply refer to the follows Fig.8:

BLACK = L

 line

WHITE = N

 neutral

GREEN/YELLOW = G 

ground

A double-pole switch properly rated must be installed to provide the range hood power 

supply disconnection. The appliance must be installed at a minimum height of 26 inches 

(66 cm) from an electric cooker stove, or 30 inches (76 cm) from gas or combined cooker 

stoves. If a connection ductwork composed of two parts is used, the upper part must be 

placed outside the lower part. Do not connect the range hood exhaust duct air to the 

same duct air used to exhaust hot air or fumes from other appliances other than electrical. 

Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.7) 

so that the unit is easier to handle.

  WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO 

PERSONS, OBSERVE THE FOLLOWING: Before making electrical connections to 

power supply, the electrical box must be secured in place as indicated in Fig.1.

•  Before installing the appliance fix the electrical box as indicated in Fig.1:

- Remove the central screw Fig.1A.

- Lift the electrical plant box Fig.1B.

- Remove the 3 fixed screws Fig.1C.

- Position the electrical box so it is in line with the holes of the previously removed screws 

Fig.1D and tighten.

- Pay attention that the tear tape of the electrical box is inside the slot and then tighten 

screw Fig.1E.

•  Fixing to the wall:

Drill the holes 

A

 respecting the distances indicated (Fig.3). Fix the appliance to the wall 

and align it in horizontal position to the wall units. When the appliance has been adjusted, 

definitely fix the hood using the screws 

A

 (Fig.5). For the various installations use screws 

and screw anchors suited to the type of wall (e.g. reinforced concrete, plasterboard, etc.). If 

the screws and screw anchors are provided with the product, check that they are suitable 

for the type of wall on which the hood is to be fixed.