background image

ings:
Green Light: less than 6 working hours
Yellow Light: between 6 and 12 working hours
Red Light: more than 12 working hours (the grease filter should
be cleaned or eventual changed).
To re-set the Timer, once the hood is switched-off, push for more
than 5 seconds the bottom T.

Lamp Replacement

The hood has a halogen lamp, take care to not touch it with your
hands when you replace it. Use a dry and not greasy protection
(for example a cloth) in order to avoid a direct contact with skin that
could make the lamp break. Never use lamps with wattage higher
than the one shown on the label inside the hood.

Safety rules

Do not do any flambé cooking underneath the hood. When frying,
never leave the pan alone because the cooking oil could flare up.
Clean all the surfaces frequently to avoid danger of fire. This can
be done with a cloth or/and with a brush drenched with denatured
alcohol or with any other similar substances, except for the button
area (pict. 3). It is also important to remove and clean or substitute
frequently the filter installed in the hood.

Maintenance

NOTE: 

Prior to any maintenance, switch off and disconnect from

electrical supply.
1) Under normal cooking conditions the grease filter should be

cleaned every 10-15 days in hot water, to which a suitable
detergent has been added. For reasons of efficiency and
safety regular cleaning is advised. The grease filter may be
subject to a small amount of shrinkage initially.

2) The outer casing of the Cooker Hood should be cleaned with

a damp cloth.

Grease filter

This absorbs vapour-suspended grease particles and protects
the kitchen and furniture from greasy residues.  The filter should
be washed every 10 to 15 days (in normal operating conditions).
Dip the filter into a de-greaser solution or put it in the dishwasher.
Make sure not to damage the filter, which is made of several layers
of thin alloy, by hitting or crushing it.
The aluminium filter may change colour, that will have no influ-
ence of the efficiency of the filter, may it improve it.

Replacing or cleaning the filters

It is sufficient to pull the handle down, and then proceed with the
cleaning of the filter and repeat the operation in the opposite way
(pict. 1/1). For a few models equipped with a handle as in Pict. 1/
2 it is sufficient to press the handle towards the rear and rotate
towards the bottom. To remove the aluminium grease filter (pict.
1/3), grab the opening tongue at the filter, pull it in your direction
and move the filter downwards. To reinstall it operates reversed.

1)

READ AND SAVE THESE INSTRUCTIONS

2)

WARNING - TO REDUCE THE RISK OF A RANGE TOP

GREASE FIRE:

     A. Never leave surface units unattended at high settings.

Boilovers causes moking and greasy spill overs that
may ignite. Heat oils slowly on low o rmedium settings.

       B. Always turn hood ON when cooking at high heat or when

flambeing food (i.e.Crepes Suzette, Cherries Jubilee,
Peppercorn Beef Flambe’).

      C. Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or filter.

      D. Use proper pan size. Always use cookware appropriate

for the size of the surface element.

3)

WARNING - To Reduce The Risk Of Fire Or Electric Shock,
Do Not Use This Fan With Any Solid-State Speed Control
Device.

4)

WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOL-
LOWING:

 A. Use this unit only in the manner intended by the manu

facturer. If you have questions, contact the manufacturer.

 B. Before servicing or cleaning unit, switch power off at service

panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the
service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the
service panel.

5) CAUTION - For General Ventilating Use Only. Do Not Use To

Exhaust Hazardous Or Explosive Material And Vapors.

6) WARNING - TO REDUCE THE RISK OF INJURY TO PER-

SONS IN THE EVENT OF A RANGE TOP FIRE, OBSERVE THE
FOLLOWINGa:
A. SMOTHER FLAMES with a close-fitting lid, cookie sheet,

or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS.

I

f the flames do not go out immediately. EVACUATE AND

CALL THE FIRE DEPARTMENT.
B. NEVER PICK UP A FLAMING PAN - You may be burned.
C. DO NOT USE WATER, including wet dishcloths or towels

- a violent steam explosion will result.

D. Use an extinguisher ONLY if:

1. You know you have a Class ABC extinguisher, and you
already know how to operate it.
2. The fire is small and contained in the area where it
started.
3. The fire department is being called.
4. You can fight the fire with your back to an exit.

a. Based on “Kitchen Firesafety Tips” publisshed by NFPA.

7)

WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR INJURY TO PERSONS, OBSERVE THE FOL
LOWING:

A. Installation Work And Electrical Wiring Must Be Done By

Qualified Person (s) In Accordance With All Applicable
Codes And Standards, Including Fire-Rated Construc
tion.

B. Sufficient air is needed for proper combustion and ex

hausting of gases through the flue (chimney) of fuel
burning equipment to prevent backdrafting. Follow the
heating equipment manufacturer’s guideline and safety
standards such as those published by the National Fire
Protection Association (NFPA), and the American Society
for Heating, Refrigeration, and Air Conditioning Engineers
(ASHRAE) and the local code authorities.

C. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

D. Ducted fans must always be vented to the outdoors.
E. If this unit is to be installed over a tube or shower, it must

be marked as appropriate for the application and be
connected to a GFCI (Ground Fault Circuit Interrupter)-
protected branch circuit.

F. NEVER place a switch where it can be reached from a tub

or shower.

8) WARNING - To reduce the risk of fire, Use only metal

ductwork.

Summary of Contents for K36PROX










Reviews: