14
E
E
E
E
E
BERTAZZONI
A4
BERTAZZONI
A4
BERTAZZONI
A4
STEP-BY-STEP INSTALLATION GUIDE
A2.
USE TOP CABINET TEMPLATE FOR PREPARATION
OF TOP CABINET
Drill holes for the top support screws, a hole large enough
for the power cord to fit through and a cutout large enough
for the exhaust adapter.
1.
Read the instructions on the Top Cabinet Template.
2.
Tape the template underneath the top cabinet bottom.
3.
Drill the holes, following the instructions on the Top
Cabinet Template.
CAUTION
Wear safety goggles when drilling holes in
the cabinet bottom.
A3.
CHECK FOR PROPER DAMPER OPERATION
1.
Place the microwave in its upright position with the top of
the unit facing up.
2.
The exhaust adapter is only used for top exhaust and
rear outside exhaust. The exhaust adapter is not used on
models vented for recirculation exhaust.
3.
Make sure tape securing damper is removed and damper
pivots easily before mounting microwave.
Back of microwave
Damper
Blower plate
Exhaust adapter (not included on models shipped for recirculation exhaust)
4.
Attach the exhaust adapter to the blower plate by sliding
it into the guides. Secure the adapter with one provided
Sheet Metal Screw.
Sheet metal screw
Guide
Blower plate
Guide
5.
You will need to make adjustment to ensure proper align-
ment with your house exhaust duct after the microwave
is installed.
A4.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT:
Do not grip or use handle during installation.
If filler blocks are not used, outer case damage may occur
from over tightening screws.
Note:
If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
We recommend using filler blocks if the cabinet front hangs
below the cabinet bottom shelf.
When mounting the microwave oven, thread power cord
through hole in bottom of top cabinet. Keep it tight throughout
steps 1–4. Do not pinch cord or lift oven by pulling cord.
1.
Lift microwave, tilt it forward and hook slots at back bottom
edge onto four lower tabs of mounting plate.
2.
Rotate front of oven up against cabinet bottom.
3.
Attach the microwave oven to the top cabinet.
4.
Insert two cabinet mounting bolts through outer top cabinet
holes. Temporarily secure the oven by turning the screw
at least two full turns after the threads have engaged (it
will be completely tightened later). Be sure to keep power
cord tight. Be careful not to pinch the cord, especially when
mounting flush to the bottom of cabinet.
Nylon grommet
Metal cabinet
Power cord
Power cord
hole
Turn two full turns on each screw
Cabinet mounting bolt
Washer
Summary of Contents for KOTR24MXE
Page 22: ......
