20
E
E
E
E
E
BERTAZZONI
A4
BERTAZZONI
A4
BERTAZZONI
A4
STEP-BY-STEP INSTALLATION GUIDE
C3. ADAPT BLOWER FOR RECIRCULATION
1.
Remove and save screw that holds blower motor to
microwave. Lift up the blower plate.
Back of
Blower plate screw
Blower motor screw
microwave
Blower motor
2.
Carefully pull out the blower unit. The wires will extend far
enough to allow you to adjust the blower unit.
BEFORE: Fan blade
openings facing UP
3.
Rotate blower unit counterclockwise 90°.
Before rotation
After rotation
Back of microwave
Back of microwave
4.
Place the blower unit back into the opening.
AFTER: Fan blade
openings facing FRONT
Back of microwave
CAUTION
Do not pull or stretch the blower unit wiring.
Make sure the wires are not pinched.
Note:
The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
5.
Replace the blower plate in the same position.
C4.
MOUNT THE MICROWAVE OVEN
FOR EASIER INSTALLATION AND PERSONAL SAFETY,
WE RECOMMEND THAT TWO PEOPLE INSTALL THIS
MICROWAVE OVEN.
IMPORTANT:
Do not grip or use handle during installation.
If filler blocks are not used, case damage may occur from
over tightening screws.
Note:
If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
We recommend using filler blocks if the cabinet front hangs
below the cabinet bottom shelf.
When mounting the microwave oven, thread power cord
through hole in bottom of top cabinet. Keep it tight throughout
steps 1–4. Do not pinch cord or lift oven by pulling cord.
1.
Lift microwave, tilt it forward and hook slots at back bottom
edge onto four lower tabs of mounting plate.
2.
Rotate front of oven up against cabinet bottom.
3.
Attach the microwave oven to the top cabinet.
4.
Insert two cabinet mounting bolts through outer top cabinet
holes. Temporarily secure the oven by turning the screw
at least two full turns after the threads have engaged (it
will be completely tightened later). Be sure to keep power
cord tight. Be careful not to pinch the cord, especially when
mounting flush to the bottom of cabinet.
Nylon grommet
Metal cabinet
Power cord
Power cord
hole
Summary of Contents for KOTR24MXE
Page 22: ......
