E
7
• Carefully match the exhaust opening location of the
microwave and attach the damper to blower motor cover
by sliding it into the guides at the blower motor cover. See
Figure 16-2, 17.
Damper
3
2
Figure 16-2
Figure 17
Be sure that the damper hinge is on the front and the
damper swings free into the wall outlet.
8. Oven Installation
THIS OVEN CANNOT BE PROPERLY INSTALLED WITHOUT
REFERRING TO THE MOUNTING INSTRUCTIONS FOUND
ON BOTH TEMPLATES.
READ AND FOLLOW MOUNTING INFORMATION ON BOTH
TOP CABINET AND WALL TEMPLATES.
Mounting Plate
STEP 1 - SETUP POSITION
• Draw a line down the middle of the studs (see Wall
Construction, page 3).
• Draw a vertical line on the wall at the center of the 30” wide
space. See Figure 18.
NOTE:
Use the wall template for the rear wall. Reference
Wall Template prior to proceeding. Installation of this product
requires 2 people.
A
C
C
B
C
C
Power Supply Cord Hole
House Duct
Mounting Plate
Figure 18
STEP 2 - DRILLING
Reference the Wall Template.
STEP 3 - TIGHTENING THE SCREWS
To attach the mounting plate to the wall using the toggle bolt
assemblies and/or lag screws:
• Insert toggle bolts through mounting plate at required
locations and add the spring loaded toggles. See Figure 19.
Be sure you leave space at least the thickness of the wall
between the mounting plate and the end of the toggle nut,
(in closed position). If you do not leave this space, the toggle
nut will not open on the other side of the wall.
Figure 19
• Position mounting plate on wall and insert toggle bolt
assemblies through the drywall holes or start the lag
screw(s) through the wall stud(s). See Figure 20.
Dry Wall
Space more than
wall thickness
Figure 20
