Bertazzoni KPH XT Series, Installation And User Manual

- 10 -

   INSTALLATION INSTRUCTIONS.
   OPERATING INSTRUCTION.

   READ AND SAVE THESE INSTRUCTIONS.

   GENERAL

Carefully read the following important information regarding installation safety and 

maintenance. Keep this information booklet accessible for further consultations. The 

appliance has been designed for use in the ducting version (air exhaust to the outside 

- Fig.1B).

   INSTALLATION INSTRUCTIONS

•  Electric Connection (Fig.10):

For connection to the power supply refer to the follows Fig.12:

BLACK = L

 line

WHITE = N

 neutral

GREEN/YELLOW = G 

ground

A double-pole switch properly rated must be installed to provide the range hood power 

supply disconnection. The appliance must be installed at a minimum height of 26 inches 

(66 cm) from an electric cooker stove, or 30 inches (76 cm) from gas or combined cooker 

stoves. If a connection ductwork composed of two parts is used, the upper part must be 

placed outside the lower part. Do not connect the range hood exhaust duct air to the 

same duct air used to exhaust hot air or fumes from other appliances other than electrical. 

Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.6) 

so that the unit is easier to handle.

•  

We recommend the use of an air exhaust tube which has the same diameter as the air 

exhaust outlet hole (Ø 5 7/8”). If a pipe with a smaller diameter is used, the efficiency of 

the product may be reduced and its operation may become noisier.

•  Fixing to the wall:

Drill the holes 

A

 respecting the distances indicated (Fig.2). Fix the appliance to the wall 

and align it in horizontal position to the wall units. When the appliance has been adjusted, 

definitely fix the hood using the screws 

X

 (Fig.5). For the various installations use screws 

and screw anchors suited to the type of wall (e.g. reinforced concrete, plasterboard, etc.). If 

the screws and screw anchors are provided with the product, check that they are suitable 

for the type of wall on which the hood is to be fixed.

•  Fixing the decorative telescopic flue:

Arrange the electrical power supply within the dimensions of the decorative flue. If your 

appliance is to be installed in the ducting version, prepare the air exhaust opening. Install 

the upper decorative flue’s support bracket and fix it on the wall using the screws 

A

 (Fig.3) 

so it is in axis with your hood and respecting the distance from the ceiling shown in Fig.2. 

Connect flange 

C

 to air extraction hole via an air extraction pipe (Fig.5).

ATTENTION

: 

only for models KPH48XT before installing the decorative chimneys, mount the bracket