Bertazzoni KU100PRO1XA, Installation Instructions Manual

Constant maintenance ensures the correct operation and efficiency of the appliance over time. 

Special attention should be paid to the metal grease-trapping filters and the charcoal filters. Fre

-

quent cleaning of the filters and their supports will ensure that fats and grease do not accumulate 

on the range hood, with the consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore should be washed 

every month in hot water and detergent, without bending them. Wait until they are completely dry 

before repositioning them. This operation should be performed at regular intervals.

2. CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through them. The air is purified

by passing a number of times through the filters and being recirculated into the kitchen.

The charcoal filters cannot be cleaned, and should be replaced on average every 3-4 months

(according to use). 

3. CLEANING THE OUTSIDE OF THE APPLIANCE

It is advised to clean the external hood surfaces at least every 15 days in order to avoid that

oily or greasy substances affect the steel surfaces.

The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid detergent 

or denatured alcohol.

In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using clean with 

a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain abrasive substances, 

rough cloths or cloths specifically designed for cleaning steel. Using abrasive substances or rough 

cloths will inevitably damage the finish of steel. The steel surface will be irrevocably damaged if 

the instructions above are not complied with.

Keep these instructions together with the instructions for use of your hood.

The manufacturer accepts no liability for any damage caused by non-compliance with the instruc-

tions above.

4. CLEANING THE INSIDE OF THE APPLIANCE

The electrical parts or parts of the motor assembly inside the range hood must not be cleaned 

using liquids or solvents.

WARNING

:

 Failure to install the screws or fixing device in accordance with these instructions

may result in electrical hazards.

In the table in Figure 3 you can verify the model, bought, and identify measures for the holes (H - 

G, B).

Take measurements from the hob, mark with a pencil on the wall where to drill the points (Fig. 5 

Step 1).

Drill, insert the screw anchors ø 8mm and partially tighten the screws (Fig. 5 Step 2-3), Hook the 

hood to the screws, tighten the screws after checking if the hood is in the bubble.

To prevent the dropping of the hood due to pressure from below, fasten it to the wall with screws 

(Fig. 6 Step 1 - 2 - 3).

MAINTENANCE AND CLEANING

HOOD INSTALLATION