10
EN
Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to indicate
that the time shown is not correct.
The oven will not operate until the clock, the water
hardness parameter and the Calibration is set.
To set the clock and the water hardness parameter
value proceed as described in the following
chapters.
Setting the clock
To set the clock, proceed as follows:
1. Press the
Clock
key a few seconds. The hour
numbers will start to flash (not necessary if your
Steam oven is first plugged in or after a power
failure).
2.
Press the “
+
” and “
–
” to set the correct hour
value.
3. Press again the
Clock
key to set the minutes.
The minute numbers will start to flash.
4.
Press the “
+
” and “
–
” to set the correct minute
value.
5. To finish, press the
Clock
key again.
Hiding/Displaying the Clock
If the clock display disturbs you, you can hide it by
pressing the
Clock
setting key.
If you want to see the clock display again, press the
Clock
setting key again.
Water Hardness setting
The appliance features a system that automatically
indicates when it is time to descale.
The system can be optimised for households with very
soft water (also through using a water softening
appliance) and very hard water, by changing the user
settings to the relevant range of water hardness (see
table below).
To set the water hardness parameter, proceed as
follows:
1. After setting the clock the hardness number will start
to flash on the Descale display (not necessary if your
Steam oven is first plugged in or after a power
failure).
2.
Press the “
+
” and “
–
” to set the correct water
hardness parameter value, according to the below
table.
3. Press the
Descale
key to set the parameter. The
Descale display switches off.
Type
Water hardness
Display
Ca + Mg
(ppm)
English deg.
[°eH]
French deg.
[°dF]
German deg.
[°dH]
Soft water
0 to 150
0 to 11
0 to 15
0 to 8
1
Medium water
151 to 350
12 to 25
16 to 35
9 to 20
2
Hard water
351 to 500
26 to 35
36 to 50
21 to 28
3
