14
82.321-M - Pulvasol 1 and 2 / Pulvigne
FILLING
- Close the drain valves (see figure 8, page 20)
According to the cases:
- place the valve (V1) in position
.
- place the valve (V2) in position
.
- place the valve (V4) in position
.
OPERATION WITHOUT FILLER PIPE
- Remove the lid on the top of the tank.
- Fill through the filler hole in your tank.
USING THE FILLER PIPE
For this system to work properly, it is necessary to have some water in the tank to prime the pump before
starting it.
- For 30 to 50 litres of water into the filler hole through the filter.
- The filling rate can be increased considerably using the hydro-injector.
SPRAYERS WITH VANNOFILTER (800 L)
The vannofilter (figure 1) must be open. Check that it is.
- If not:
to open it
, pull item (1) towards you, then turn it a quarter of a turn to put it in position (2).
- If leaking occurs at the cover, slightly tighten the star-shaped knob (3).
CONNECTING THE FILLER HOSE
-
With B.P. pumps
(figure 2) :
Connect it directly to the hydro-injector’s (1) suction hose:
- Remove the plug (2) and connect the filler hose (3) in its place.
FILLING
1. Engage the tractor’s power take-off
and raise rotation speed to 540 rpm.
2. Your tank will start to fill.
Keep the rotation speed of the power take-off at 540 rpm.
3. When filling is complete:
- reduce the engine speed (tick-over),
- take the hose (3) out of the water point. This has the effect of emptying it (3) (figure 2),
- remove the hose (3) from the hydro-injector (1),
- re-fit the plug (2).
ADJUSTING THE CONTROL VALVE
(figure 3)
:
- With rinsing tank option: place the valves (V3) in position
(figure 8, page 20).
- Put the supply plugs on the spray boom sections in position (1).
- Put the handle on the main valve in position (2).
Summary of Contents for PULVASOL 200
