3
R e
arw
ard
-fa
cin
g
fitti
ng
of
an
ch
or
be
lts
.
Alternative C – Fitting in the front seat
1.
Join the two anchor belts together to make
a single belt by putting the lock of belt 1
through the loop of belt 2 and then through
the loop of belt 1.
Pull tight. See fig. 3a
2. Put the middle part of the anchor belt
Fig. 3a
Fig. 3a over the inner part of the car seat.
Cross the two ends of the anchor belt under
the car seat and bring them upwards towards
where the child seat is to go. See fig. 3b
3. As the child seat is on top of a soft car seat,
it will always be able to move slightly. In some
cars the child seat will be more stable using
Alternatives A or B.
This method can only be used when the
child seat is mounted on the front seat. Fig. 3b
Fig. 3b
Alternative D – Fitting to the back seat
1.
Insert the belt loop through the gap between the
seat cushion and the seat back on the front seat.
Then bring the locking device through the belt loop
and tighten. See fig. 4a
2. Do the same on the opposite side of the front seat.
3. When positioning the
Fig. 4a
child seat on the car's back
seat, cross the anchor belts
behind before fixing them to
the child seat.
See fig. 4b
Fixing to the front seat
When positioning the child
seat in the car’s front seat,
use the same method for
fitting the belts but they must
cross under the seat as in fig.3b
Fig. 4b
