BESAFE iZi Modular Base, User Manual

10

11

5. When installing in the front seat of the vehicle, adjust the back rest 

into an upright position. (12)

6. If your vehicle is not equipped with ISOfix insertion clips, insert 

these to make installation easier. (13)

7. ISOfix insertion clips are underneath the base.

8. When the base is lifted the floor support should fall downwards 

from underneath the base. Do this outside the car. (14)

9. Push down one of the grey ISOfix releases on top of the base. The 

ISOfix connectors will appear at the back of the base. Pull the ISOfix 

connectors fully out. (15)

10. Position the base on the vehicle seat. Click the ISOfix connectors on 

to the ISOfix points on the vehicle seat. Make sure that both ISOfix 

indicators are green. (16)

11. During installation, you can prevent the ISOfix connectors from 

sliding in, by pushing at least on one side on the marked area in 

front of the grey isofix release switch. (16)

12. Push the base against the backrest of the vehicle seat until it is 

firmly in place. (17)

13. Remove the yellow cap from the floor support. The alarm sound will 

stop when the seat is installed correctly with the floor support in 

contact with the floor of the vehicle. (18)

14. Adjust the floor support, so it is in contact with the floor of the 

vehicle. (19)

15. The height indicator of the floor support shows green when the 

floor support is in contact with the floor. (20)

16. The alarm sound stops when the floor support indicators show 

green and it is in contact with the floor. (20)

• 

The child seat MUST NOT be installed in a front 

passenger seat WITH AN ACTIVATED AIRBAG.

• 

The floor support must always be used. Make sure that 

the floor support is fully pushed down.

• 

When used in combination with iZi Modular the front brace must 

be fitted on the base. 

• 

Make sure the indicators are green before you drive.

 ! Warning: potential misuse

Guarantee

Removal of the base from the vehicle

• 

Should this product prove faulty within 24 months of purchase 

due to materials or manufacturing fault, except covers and harness 

straps, please return it to the original place of purchase.

• 

The guarantee is only valid when you use your seat appropriately 

and with care. Please contact your retailer, they will decide if the 

seat will be returned to the manufacturer for repair. Replacement 

or return cannot be claimed. The guarantee is not extended 

through repair.

• 

The guarantee expires: when there is no receipt, when defects are 

caused by incorrect and improper use, when defects are caused by 

abuse, misuse or negligence.

1. To remove the base from the vehicle, you have to slide the 

central grey ISOfix release switch towards the front. Both isofix 

connectors will release from the vehicle 

2. If removal is difficult, it can help to push the base towards the 

backrest of the vehicle, while pulling the ISOfix release switch.