11
2. Push the
AREA
button to scroll thru and select the desired
location. Once you have selected the desired memory
location enter your dimension
Use the ▲ (UP) button to change the flashing digit
Use the ◄ (LEFT) button to move the decimal
Use ► (RIGHT) button to select the other digits. After all of
the digits are entered, press and hold the
AREA
button (until
it beeps twice) to save the area into memory and return to
CFM or CMM measuring mode.
To select and use a previously stored dimension, press and hold the
AREA
button until it beeps twice.
Press
AREA
to scroll thru the 8 memory locations. Press and hold
the
AREA
button until it beeps twice. to return to CFM or CMM
measuring mode.
Air Flow Measurements (Up to 20 Point averaging)
1. To enter 20 Point Averaging Mode, press and hold the
AVG
button until it beeps twice. The
AVG
icon will be displayed.
2. Take a measurement and press the
AVG
button. A single
beep will sound and the
HOLD
icon will appear in the display.
3. The average reading will be displayed and number of readings
measured will appear in the upper right hand corner of the
display. After 5 seconds, the display will return to the current
reading. (IMPORTANT: Please note that the average
readings are only held for 5 seconds and cannot be recalled.)
4. Repeat steps 2 - 3 until all desired points have been
measured.
5. Press the
AREA
button to clear the multipoint averaging
memory.
6. To return to standard airflow measuring mode press and hold
AVG
button until meter beeps twice.
