-
BESANTEK
-
Disposal
Follow the valid legal stipulations in respect of the
disposal of the device at the end of its lifecycle
lnfraRed Measurement Considerations
• When taking IR measurements the meter automatically
compensates for ambient temperature changes. Note that it
may take up to 30 minutes to adjust to extremely wide
ambient changes
.
• Low temperature measurements quickly followed by high
temperature measurements may require several minutes to
stabilize as a result of the IR sensor cooling process.
• If the surface of the object under test is covered with frost, oil,
grime, etc., clean before taking measurements.
• If an object's surface is highly reflective apply masking tape or
flat black paint before measuring
.
• Steam, dust, smoke
,
etc. can obstruct measurements.
• To find a hot spot, aim the meter outside the area of interest
then scan across (in an up and down motion) until the hot spot
is located.