10
(1) [Basic Set
ti
ngs] Logger parameter set
ti
ngs
Name: can be named according to the actual situa
ti
on, the name of each instrument can not be repeated.
Serial Number: Enter the 10-digit serial number posted on the instrument.
Instrument Type: Set to "Wireless Instrument".
Sampling interval (minutes): The refresh interval of instrument data can be set according to the actual situa
ti
on.
The number of sensors: select a single channel shows only 1 (only display the data of a channel, single
temperature recorder can select this), select dual channel display 2 (display two channels of data, temperature
and humidity recorder can select this ).
（
2
）
[Sensor I]
High : the upper limit can be set. When the set value is exceeded, the monitoring value is displayed in the red font.
Please set the alarm mode to send the alarm informa
ti
on according to the actual demand.
Low : the lower limit can be set. When the set value is exceeded, the monitoring value is displayed in red font.
Please set the alarm mode to send the alarm informa
ti
on according to the actual demand.
Type: temperature/humidity (please choose according to the type of purchase recorder).
（
3
）
[Sensor II]
High / low : The upper limit and lower limit can be set according to the actual situa
ti
on. When the set
ti
ng value is
exceeded, the monitoring value will be displayed in red font, meanw hile, the alarm informa
ti
on will be sent
according to the set
ti
ng alarm mode.
Type: temperature / humidity
Sound & Light Alarming: Optional working hours are off or open all the
ti
me.
Add button func
ti
on: First, select one of the recorder in the dialog box, the proper
ti
es displayed, enter a new
name and serial number, other parameters set according to the actual situa
ti
on, and then click to increase.
Apply button func
ti
on: First, select one of the recorder in the dialog box, set the relevant parameters according to
the actual situa
ti
on, click the Modify button will pop up to modify the success dialog box, and then click OK.
Delete button func
ti
on: First, select one of the recorder in the dialog box, click the delete button will pop up to
delete the success dialog box, and then click OK.
Exit button: Click the Exit button to exit the Device Management dialog box.
2.3.7 Real-
ti
me curve button
Click
, The window is displayed as a curve, as shown below:
