5 - USB
interface :
for the instrument access to the computer.
1
�1 LQ
0
[-a
2
___,_,
0 0 0
--
7
ILILI.LI
3 ---+--0
LOG-6
4--------'
.__ _____ 5
Figure 2-2 LCD display diagram
1
-
Set upper temperature mark:
meaning the instrument displays the set temperature
upper limit.
2 -
Set lower temperature mark:
meaning the instrument displays the set temperature
lower limit.
3 -
Battery Level
: Full grid is 3 grid
4
-
Min temperature mark:
indicating that the instrument shows the minimum
temperature of the recorded temperature at this time.
5
-
Max temperature mark:
indicating that the instrument shows the maximum
temperature of the recorded temperature at this time.
6
-
Recording mark:
mean
i
ng the
i
nstrument is recording data now.
7 -
Real-time temperature
8
-
Temperature units:
0
c
and l can be switched display
2.21nstrument instructions
Use Step
: set the instrument and synchronize the time - instrument turn on and
boot into calibration mode - the instrument turn on again
,
and recording data normally -
connect to the computer
,
open the PDF view and save data - end use.
1.Set the instrument and synchronize the time
: Connect to the computer by USS
interface - Open the Datalogger software - Click [Get] to get the instrument
configuration - Pop-up the ok prompt window, click [OK] - set the instrument upper
and lower limits alarming and interval logging - click [Sync Setting] synchronization
settings.
3
BESANTEK Corporation, CANADA