Additional Service and Maintenance for IDH Max Locks
W Series Service Manual
6–15
To disconnect the connections and remove the outside escutcheon:
5. Remove the escutcheon gasket from the outside escutcheon and
discard the gasket.
6. Unscrew the two reader electronic mounting screws on the reader
circuit board and remove the harness clamp. Save the harness clamp
and screws.
7. Carefully pull the reader circuit board assembly straight out from the
escutcheon.
Note:
You can carefully set aside the reader circuit board and sounder
affixed to the outside escutcheon.
8. Unscrew the four bezel mounting screws. Save the screws.
9. Remove the proximity card reader assembly from the outside
escutcheon.
Reinstalling the proximity card reader assembly
1. Orient the proximity card reader assembly and insert the pins
through the slots in the outside escutcheon.
2. Position the proximity card reader assembly on the reader gasket
and install the four bezel assembly mounting screws.
3. Align the connectors on the back of the reader circuit board
assembly with the reader pins. Press the board into place.
4. Loosely install the two reader electronics mounting screws.
Figure 6.6
Removing and replacing the proximity card reader
Proximity card reader assembly
Outside escutcheon
Slot
Reader gasket
Location of prongs
Summary of Contents for 34HW
