Installation Instructions for 34HW–35HW IDH Max Mortise Locks
BEST ACCESS SYSTEMS
Indianapolis, Indiana
Preparing the door and door jamb
4
1
Mark centerlines
Note:
If the door is a fabricated hollow metal door,
determine whether it is properly reinforced to support
the lock. If door reinforcement is not adequate, consult
the door manufacturer for information on proper
reinforcement. For dimensions for preparing metal
doors, see the
W13 Template—Installation
Specifications for 34HW–35HW IDH Max Mortise
Locks
.
1 On the door, measure and mark the height of the
centerline of the knob/lever from the floor (38
″
recommended). On both sides of the door, on the
door’s edge, and on the door jamb, mark the
horizontal centerline of the lock 1 1/2
″
above the
centerline of the knob/lever.
Note:
If the door is a LH or RH door, mark the inside of
the door. If the door is a LHRB or RHRB door, mark the
outside of the door.
2 On the door’s edge and door jamb, mark the vertical
centerline of the lock.
3 Measure and mark the backset (2 3/4
″
standard) from
the vertical centerline on the door’s edge. On both
sides of the door, mark the vertical centerline of the
lock.
4 On the door jamb, mark the horizontal centerline of
the strike 3/8
″
above the horizontal centerline of the
lock.
2
Position template and mark drill points
1 Cut
the
W15 Template—Installation Template for
34HW–35HW
IDH Max Mortise Locks
along the dashed
lines and align the horizontal and vertical arrows with
the marked centerlines on the door.
2 Tape the template to the door.
3 Center punch the necessary drill points. Refer to the
instructions on the template.
Figure 1
Marking the centerlines
Door jamb
Door
Vert. centerline
of lock
Horz. centerline
of lock
Horz. centerline
of knob/lever
(38
″
from floor
recommended)
Vert. centerline
of door’s edge
Horz. centerline
of strike
Vert. centerline
of strike
Figure 2
Positioning the template
Installation template
Horizontal centerline
of lock
Horizontal centerline
of knob/lever
Vertical centerline
of lock
Summary of Contents for 34HW
