Service and Maintenance for Mortise Locks
4–16
W Series Service Manual
Task D. To reinstall the cylinder and mortise case faceplate:
Note:
Install the cylinder for EEL and EEU function locks only.
1. Thread the concealed cylinder into the mortise case so that the
groove around the cylinder head is even with the door surface.
Adjust the cylinder depth plus or minus one turn so that the core,
when installed in the cylinder, is flush with the outer surface of the
escutcheon.
Caution
A malfunction can occur if the cylinder is threaded in too far.
2. Secure the cylinder in the mortise case with the cylinder clamp
screw.
3. Secure the mortise case faceplate to the mortise case with the
faceplate mounting screws.
4. Check the cylinder and lock for proper operation.
Figure 4.17
Reinstalling the cylinder and mortise case faceplate
Outside of door
Concealed cylinder
Cylinder clamp screw
(inside mortise case)
Mortise case faceplate
Faceplate mounting screw
Faceplate mounting screw
Summary of Contents for 34HW
