Service and Maintenance for Mortise Locks
W Series Service Manual
4–19
Caution
When connecting the reader wire harness, make sure:
■
there are no loose wire connections where the wires are inserted
into the reader wire connector
■
the reader wire harness connector is fully seated in its mating
connector on the control electronics circuit board.
Figure 4.20
Connecting the reader wire harness to the control electronics circuit
board
Reader wire harness
connector
Sensor wires and
solenoid wires
Solenoid and sensor
wire harness
Inside of door
Inside escutcheon
Control electronics
circuit board
Large opening
Summary of Contents for 34HW
