Installation Instructions for 45HM IDH Max® 1300 Mortise Locks
BEST ACCESS SYSTEMS
a Division of Stanley Security Solutions, Inc.
Configuring & installing the mortise case
6
9
Position hub toggles
(if necessary)
1 Check whether the hub toggles are in the proper position
for the lock. See the table below and Figure 9.
Note 1:
For LH & LHRB doors, the inside is the back side of the
case and the outside is the cover side of the case.
For RH & RHRB doors, the inside is the cover side of the case
and the outside is the back side of the case. The cover is
mounted to the case with four screws.
Note 2:
If the lock has an optional RQE status sensor, two RQE
status switches are installed in the mortise case. However,
only the switch for the inside of the lock needs to be
connected. Before you install the mortise case in the door,
determine whether you need to connect the ‘Case Side’ pair of
RQE wires or the ‘Cover Side’ pair of RQE wires, based on the
handing of the door.
2 To change the position of a hub toggle, remove the toggle
screw, move the toggle into the desired position, and re-
tighten the screw.
10
Install mortise case
1 Remove the faceplate from the mortise case, if necessary.
2 Insert the mortise case into the mortise cavity, while
feeding the sensor and solenoid wires into the mortise
cavity and out the sensor & solenoid wire hole to the inside
of the door.
Note 1:
The armored front of the mortise case self-adjusts to
the door bevel.
Note 2:
The field wire harness should be routed above and
behind the mortise case (depending on where the hole
through the door meets the mortise cavity).
3 Make sure there are 3
″
to 4
″
of slack in the field wire
harness to allow access to the control electronics circuit
board in the inside trim.
3 Secure the mortise case with the case mounting screws.
Hub toggle positions
Function
Hub toggle positions
DEU/DEL, LEU/LEL, NXEU/
NXEL, TDEU/TDEL
Inside down (always unlocked) &
outside up (lockable)
Figure 9
Positioning hub toggles
Hub toggle
Hub toggle
Figure 10 Installing the mortise case (inside of door)
Field wire harness
Sensor & solenoid
wire hole and wires
Inside
trim
Inside of door
Mortise
case
