Installation Instructions for 45HM IDH Max® Mortise Locks
BEST ACCESS SYSTEMS
a Division of Stanley Security Solutions, Inc.
10
Installing the trim
15
Connect reader wire harness
1 From the outside of the door, feed the reader wire
harness connector through the field harness & reader
wire hole.
2 Temporarily rest the outside trim on the door by
inserting the trim studs into the stud holes.
Note:
You can temporarily install the outside knob/lever
to hold the outside trim in place. See Task 17.
3 Connect the reader wire harness to the control
electronics circuit board in the inside trim.
4 Feed the solenoid and sensor wire harness from the
control electronics circuit board, as well as the
solenoid and sensor wires from the mortise case,
through the large opening in the inside trim.
Figure 15a Feeding the reader wire harness connector
from the outside trim through the door
Reader wire
harness connector
Field harness &
reader wire hole
Outside trim
Outside of door
Figure 15b Connecting the reader wire harness to the
control electronics circuit board
Reader wire harness
connector
Sensor wires and
solenoid wires
Solenoid and sensor
wire harness
Inside of door
Inside trim
Control electronics
circuit board
Large opening
Caution 1:
When routing the reader wire harness,
make sure the reader wire harness is not routed
across any sharp edges or over any surface that
could damage its sleeving or wire insulation.
Caution 2:
When connecting the reader wire
harness, make sure:
■
there are no loose wire connections where the
wires are inserted into the reader wire
connector
■
the reader wire harness connector is fully
seated in its mating connector on the control
electronics circuit board.
