Servicing Exit Hardware Trim Escutcheon Parts
10–16
B.A.S.I.S. V Service Manual
S
ERVICING
THE
MOTOR
ASSEMBLY
Replacement kits are available for motor assemblies. See
page 4–10
.
Each time you service the motor assembly you need to replace the
following parts with new parts:
■
escutcheon gasket (C64564)
■
cable tie
■
lift finger screw (
page 4–9
)
■
mounting plate screws (
page 4–9
)
■
tape for mounting the sounder.
Removing the motor
assembly
1. Remove the following components:
■
escutcheon from the door (
page 8–13
)
■
mounting standoffs (
page 10–2
)
■
escutcheon gasket (
page 10–3
)
■
lift finger (
page 10–4
)
■
mounting plate (
page 10–6
)
■
lever return springs (
page 10–8
).
2. Disconnect the motor connector from the primary harness. See
Figure 10.6
.
Figure 10.6
Removing the motor assembly
Socket head screw
Sounder
Motor connector
Motor assembly
Summary of Contents for B.A.S.I.S. V
