Step 2
Assemble Sidewall
1. Cut (2) two 2x4-10' boards to a length of 10' - 0". They will be used for wall plates.
2. Position 2x4s together and indicate with 'X' marks where the wall studs will be located.
3. Install (7) seven 72" long wall studs
over the 'X' marks.
4. Place (2) two rafter halves together with the flat side against the top 2x4 wall plate.
5. Place a 2x4 center stud (pointed end) between the top plate and peak. Secure top with a
wood gusset. Apply wood glue between 2x4s and gusset. Nail the gusset to the 2x4s with
(12) twelve 6d common nails. Angle nails slightly so nails do not protrude through the 2x4s.
6. Temporarily screw (2) two 2x4 blocks along the top of 2x4 rafters. This will help with the
assembly of other gable and the trusses.
To aid in the assembly of the sidewalls, attach 2x4 packing blocks to your floor with
2-1/2" screws. This will trap the perimeter 2x4s until they are nailed together.
2x4-10' Plate
2x4 Block
2x4 Wall Plate
Gusset
Rafter Flat Side
7. Set aside the top finished gable and repeat numbers 4-6 to assemble another gable.
cen
ter s
tud
24"
11-1/4"
24"
24"
24"
X
X
X
X
X
X
X
X
X
X
X
X
X
X
