Siding Extends
3/4" Below Plate
Tip; To prevent gable studs from
being knocked loose when nailing
siding, lay 2x4 OSB sheathing,
supplied in kit, under the studs.
Step 2
Assemble Roof Gable Without Loft Doors
LAP
5.
Turn the gable over. Cut a 4x8 siding panel in half creating (2) two 4'x4' siding panels.
6.
Install the siding extending 3/4" below the bottom 2x4. Cut the top flush with the top frame.
Use 6d galv. nails. Space 12" apart.
7.
Install pre-cut siding, from our kit, on the ends.
Cut Siding Flush With Frame
Supplied in Kit
34-1/4" Long Gable Stud
21-1/2" Long Gable Stud
4.
Screw (3) three 16" long 2x4 blocks
across the bottom of the 2x4 bottom
cord. Use 2-1/2" screws.
35-3/4" Long Center Stud
1.
Place (2) two 47" long and 38" long 2x4 gable rafters, packed in extension kit, in the truss
jig and secure with 1"x4" drive-on plates. Toenail a ridge block at the ridge.
2.
Secure 2x4 gable studs to the truss with (10) ten 1"x4" metal plates.
3.
Install wood gusset to bottom of truss and the ridge.
1"x4" Drive-on Plate
38" Long Gable Rafter
47 Long Gable Rafter
1"x4" Drive-
on Plate
1"x4" Drive-
on Plate
Wood Gusset