3.
Install a 2x4 block on the opposite side wall and secure the truss.
Step 9
Install Siding on Front Wall
Step 10
Install Roof Gable
Install 2x4 Block
1.
Select a truss with a gusset installed on one side. Position this truss with
the gusset facing towards the inside of the building and flush with 2x4s
on back wall.
2.
Install a 10" to 12" long 2x4 block on a side wall using 10d sinkers.
Secure the truss to the 2x4 block with (2) two 10 sinkers.
3.
Install the 16-1/2" panel
with the 'cut' edge flush
with the door opening.
4.
Install last siding panel.
Cut Edge
Cut Edge
Cut Edge
12-1/2" Siding with 'Tongue' edge
15-3/4" Siding with 'LAP' edge
1.
Select a 12-1/2" siding panel with a 'Tongue' edge and install at the front left corner. Cut edge
will be flush with side wall siding. Install a 15-3/4" siding panel with a 'LAP' edge next. Cut
edge should be flush with door opening.
2.
Install (2) two 4-3/4" x 32-1/4" siding panels over the door opening. Bottom of siding should
extend 3/4" below header. Trim will cover where the siding panels butt together in the center.
Siding 3/4"
Below Header
