Page 12
Copyright © 2017 Best Living Systems | All Rights Reserved
Troubleshooting
WARNING! Do not operate the unit unless the
following are properly installed: DBI CELL,
REAR FILTER ASSEMBLY (with all three pieces
in place), and the REAR COVER.
CAUTION! The unit should be powered off and
the POWER CORD should be disconnected
whenever cleaning/disassembling/
reassembling/servicing.
Unit Fails to Turn On
1.
Verify that the POWER PLUG is plugged into
an operational wall outlet.
2.
Ensure that the POWER CORD is properly
connected to the POWER ADAPTER
3.
Ensure that the POWER ADAPTER PLUG is
fully seated in the receptacle on the back of
the unit.
4.
Verify the POWER BUTTON has been
activated on the CONTROL PANEL.
5.
If POWER BUTTON on the CONTROL
PANEL fails, use the POWER BUTTON
on the REMOTE CONTROL. If the unit
activates when using the POWER BUTTON
on the REMOTE CONTROL but not the
CONTROL PANEL the CONTROL PANEL is
inoperational. Contact your distributor or
Best Living Systems, LLC
(www.BestLivingSystems.com).
The PCO Cell is not Lighting Up
1.
Ensure the PCO CELL POWER CONNECTOR
is properly seated in the PCO CELL
POWER CONNECTOR OUTLET (See
“DISASSEMBLY/ASSEMBLY”).
2.
If the PCO CELL still fails to properly operate,
you will need to replace it. Contact your
distributor or Best Living Systems, LLC
(www.BestLivingSystems.com).
The DBI Cell is not Lighting Up
1. Ensure the DBI CELL is properly seated in the
DBI CELL POWER CONNECTOR
(See “DISASSEMBLY/ASSEMBLY”).
2. If the DBI CELL still fails to properly operate,
you will need to replace it. Contact your
distributor or Best Living Systems, LLC
(www.BestLivingSystems.com).
Ionization Needle Creates an Electrical Arc
The IONIZATION NEEDLE needs cleaned (See
“CLEANING: IONIZATION NEEDLE”). Be sure to
complete all of the cleaning procedures described
in “CLEANING” every 30 days of operation.
Fan Does Not Operate Properly
1.
Try adjusting the fan speed using the
CONTROL PANEL or REMOTE CONTROL
2. Remove the FRONT GRILLE (See
“DISASSEMBLY/ASSEMBLY”) and ensure
there are no obstructions to the movement of
the FAN. Clean it thoroughly and also clean
the mount that it sits on.
3. If FAN continues to operate improperly or not
at all, contact your distributor or
Best Living Systems, LLC
(www.BestLivingSystems.com).