3
To Assemble and Attach to Wall:
Identify and Separate all the Parts and Hardware.
2. Remove the right End Cap’s securing screw and the right End Cap on the Track (P-1)
assembly. Slide the Tack Strip out of the Track. You may also remove the plastic Paper
Holders out of the Track as shown in illustration #1.
3. Place your Track (P-1) on the wall at the height you have chosen and center. Draw a line
along the bottom edge of the Track. If you are mounting the Track to a stud wall, determine
the stud locations and predrill a 1/8” diameter hole through the Track in the center of the Tack
Strip’s recess and into the wall stud. Attach the Track (P-1) to the wall using the Long
Screws (A). See illustration #2.
NOTE: Make sure you have a Long Screw (A) holding the Track (P-1) at 6” or less from each
end. This may require you to install a drywall Screw Anchor (C) into the wall first and then
connect using a Long Screw (A) through the Track and into the Screw Anchor. See Detail
1.
Illustration # 2
Illustration # 1
P-1
Tack Strip
Paper Holders
End Cap
Securing
Screw
P-1
A
Drill 1/8” Dia.
Screw Hole
Studs
6”
16”
C
A
1/4” Predrill
Detail
