5
5.
Slide on two Top Brackets (P-2) over the top extrusion of your board as shown in illustration
#5. Push one Top Brackets to the far left and one to the far right of your board. Install one Top
Bracket Screw (D) into each Top Bracket (P-2) and finger tighten to secure in place.
.
Hanging a board on the Intuition Track System:
Illustration # 6
P-2
P-2
D
D
6. Assemble the Bottom Bracket (P-3) to the Bottom Wheel (P-4) using a Bottom Bracket
Screw (E) and Bottom Bracket Washer (F) as shown in illustration #6. Repeat this step
for the second Bottom Bracket assembly. Leave the Bottom Bracket Screws loose.
P-3
P-4
E
F
Illustration # 5