Installation Instructions for IDH Max 1300 Mortise Locks
BEST ACCESS SYSTEMS
A Division of Stanley Security Solutions, Inc
16
Completing the installation at the door
2 Slide the inside knob onto the inside spindle and
secure it with the set screw.
3 Push the set screw cap into the set screw hole.
4 Tighten the trim mounting screws.
5 Turn the knobs to check that they operate smoothly.
For levers
1 With the handle pointing toward the door hinges,
insert the outside lever and spindles assembly into the
lock from the outside of the door.
2 Slide the inside lever onto the inside spindle and
secure it with the set screw.
3 Tighten the trim mounting screws.
4 Turn the levers to check that they operate smoothly.
17
Install core (EEL and EEU only)
1 Insert the control key into the core and rotate the key
15 degrees to the right.
2 With the control key in the core, insert the core into
the cylinder.
3 Rotate the control key 15 degrees to the left and with-
draw the key.
Caution:
The control key can be used to remove
cores and to access doors. Provide adequate secu-
rity for the control key.
Figure 16b Installing the levers
Spindles
Set screw
Outside of door
Inside of door
Figure 17 Installing the core
Control key
Core
Inside of door