IMPORTANT INSTRUCTIONS
CAUTION: DO NOT OPERATE THE HYDRO MASSAGE SYSTEM WITH ANY PARTS OR FITTINGS REMOVED.
1. Use this unit only for its intended use as described in the manual. Do not use attachments not
recommended by the manufacturer. Any improper installation or misuse of the equipment may
result in injury to user and will void the warranty.
2. To avoid injury, exercise care when entering or exiting the hydro massage bathtub as the floor
may be slippery.
3. Do not use the door as support while entering or exiting the hydro massage bathtub, as the door
may swing suddenly with applied weight.
4. Because of the risk of hyperthermia and drowning, do not use the hydro massage bathtub after
strenuous exercise.
5. Because of the risk of electric shock, no appliances should be within 1.5 meters (5 feet) of
the bathtub, i.e., hair dryer, lamp, TV, radio, etc.
6. Do not open door until all water has been drained from the tub.
OPERATING YOUR WALK-IN BATH TUB
1. If the seat is not already out of the way, fold it in the up position before you enter the tub.
2. Enter the tub, turn around and latch the door securely. The downward motion of the door lever
locks and seals the door.
3. Fold down the seat and sit down.
4. Turn the drain valve handle (the cover of the overflow) all the way to the left (counter clock wise)
to close the drain.
5. Fill to the water level that is comfortable for you, but at least one inch above the highest water jet.
6. Read and follow the information regarding hyperthermia. However, under no circumstances use a
bathtub with water above 40°C (104°F).
7. To operate the water jets, press the on buttons on the key pad on the side of the tub with the on
and off buttons.
8. To increase or decrease the pressure from all the jets, turn the air volume control knob to the
open or closed position to allow more or less air to be drawn in to the jets.
9. To increase the pressure from an individual jet, turn the face of the jet counter-clock wise to allow
more water to the jet.
10. To operate the (optional) air jets, press the buttons on the three button key pad on the side of the
tub in the following ways:
on/off Button: The blower turns on and off.
+/- Up/down Button: The speed of the blower increases/decreases until the button is released.
+- Pulsation button:
a. The speed of the blower varies gradually from low to high and back to low.
b. The blower turns off and on, then off again.
11. The blower returns to maximum speed.
12. Unless the tub is in use, always leave the door open to maintain the integrity of the door seal.
The BigE model XTWJ6035
Walk-In Tub Installation and Operating Instructions
BigE Walk-In Tub USA/CANADA 2010 Page 7 of 14
